ViewTube

We are finally getting finished with the project to make a new feed screw for a Reed metal lathe. In this video, we will show the ...

Continuing from the machine work in part 1, we get to drilling out the slug and making use of a nice size 2 3/16" taper shank drill ...

G'day everyone, Back in the workshop again and this week I need to make another tap. I need a screw with a large pitch which is ...

This episode on Blondihacks, I'm making a lead screw for a float lock vise! Exclusive videos, drawings, models & plans available ...

This episode is all about machining the 3 TPI square thread inside the gearbox shaft. We have to first bore it to the correct size and ...

Machining a 2mm pitch square threaded leadscrew for replacing the 4mm pitch leadscrew on a cheap chinese milling table.

Pine is material that is traditionally used to build houses in Finland. Lumber made from that tree is cheap and widely available in ...

Making a new adjusting screw for a four jaw lathe chuck, not going to plan so far?

Thread cutting on the lathe. I know, I know, but had a few requests, thought I'd oblige. This is pretty general -- to help keep it clear ...

Project hit a roadblock: needed a tap I didn't have... Now I do! *Level unlocked* PS Audio gets weird in places; my apologies in ...

Sup folks! Have a little job to do for a friend that involves cutting an internal, square thread! It's my first time cutting an internal ...

Welcome to video #49 of a shop that I assembled to demonstrate the way things were done in the early days of industry and ...

How to construct a double start Square Thread using basic helices construction.

A general overview of cutting square threads on a metal lathe. Not too difficult, but there are a few tricks to it! Please go to the ...

I have a job that will require cutting some Modified 10 degree Square Threads on the lathe and needed a special threading tool to ...

Turned Ok also learnt a bit along the way.

Lecture slides available here: ...

HOW TO DESIGN POWER SCREW (SQUARE THREAD) IN CREO.

This video focused on: • the correct diameter of boring bar • how to set up boring bar and threading tool • the reason why the ...

Reconditioning a very rare threaded part for an old '' Tractor '' from the 1940's .